Update for &AOMREAD in CA NetMaster and CA SOLVE Network Control Language Reference

Document ID : KB000010429
Last Modified Date : 14/02/2018
Show Technical Document Details
Introduction:

We've updated the &AOMREAD section in the Network Control Language Reference for all CA NetMaster and CA SOLVE products.

Instructions:

In the Network Control Language Reference for all CA NetMaster and CA SOLVE products, in the &AOMREAD section update the text for the MINOR={ YES | NO } operand, as follows:

 

 MINOR={ YES | NO }

  Specifies whether &AOMREAD is to return minor lines of a multiline WTO message.

 

MINOR=YES presents the individual lines of a multiline WTO message in order, following the

  &AOMREAD of the major line.

  This setting is useful if you want to examine attributes of each line.

 

MINOR=NO causes the next &AOMREAD after reading a major line to skip all the minor lines,

   and read the next message.

Default: YES

 

Note: Regardless of this setting, the &AOMMINLN and &AOMMINLT built-in functions allow access to the text and line type of any minor line of the current message.

The &AOMNMIN system variable indicates how many minor lines there are.

The operand has no effect except in the case where the previous line read was a multiline WTO major line.

 

Thus, you can use &AOMREAD MINOR=NO in a main processing loop, and enter an inner processing loop, to read &AOMNMIN minor lines

 

[NEW LINE] 

 

Important! To make &AOMREAD read the minor lines in responses to console commands, use the screening table to route the minor lines to the AOMPROC.