Spectrum NCM “Save to Startup Task” fails after 10.2.3 Upgrade

Document ID : KB000099053
Last Modified Date : 02/08/2018
Show Technical Document Details
Issue:
After upgrading to Spectrum 10.2.3, and starting a “Save to Startup Task” for the ‘Cisco IOS – SSH Capable’ and ‘Cisco IOS’ device families, you may receive the below error:
 
SPC-OCC-11528 Missing Device Username.
Environment:
Spectrum 10.2.3
Resolution:
If you check the Device Family -> Information -> Device Configuration Transfer Settings tab you should have the following configured:

User-added image

In order to resolve this issue, please clear the credentials out of the first row of the table and enter them into the second row of the table as follows:

User-added image

Once this is set, please re-run the “Save to Startup Task” and it should now run successfully.

This is a known issue and a permanent resolution will be included in the Spectrum 10.3.0 release.

NOTE: By right-clicking the table columns and selecting "Sort" - this will rearrange the table and put the credentials back on line 1 and reproduce the issue. For a more stable workaround, try adding credentials to each line of the table. Thus even if the table is "sorted" there will always be credentials on line 2 which is the line that works. 
User-added image
Additional Information:
If you have performed the above steps and are still experiencing this issue or any other issues, please do not hesitate to contact CA Support.