snmpcollector is not able to discover interfaces on cisco nexus

Document ID : KB000100122
Last Modified Date : 05/06/2018
Show Technical Document Details
Issue:
We created a profile for cisco nexus.
We are using snmp V3 for the device.
After discovery is finished, no interface components visible in probe GUI.
 
Environment:
snmpcollector 3.43
target device is cisco nexus
Cause:
If snmp v2 or v3 is used, we use 20 oids in a snmp bulk get request.
It caused cisco nexus to be busy to respond to our snmp request.
Resolution:
1. Open snmpcollector probe in Raw Configure.

2. Set the below key in <setup> section

MAX_BATCH=3

3. Apply

4. Run "Force Component Rediscover" for cisco nexus profile.
Additional Information:
https://communities.ca.com/docs/DOC-231179273-tech-tip-maxbatch-in-snmpcollector-and-caveats