Not getting DC329019 V10 T22 Resynchronization completed successfully for SATDAYNA::DSI_CLI at startup.

Document ID : KB000012262
Last Modified Date : 14/02/2018
Show Technical Document Details
Question:

The DC329019 V10 T22 Resynchronization completed successfully was not written to the log at startup, why would this message be missing at startup?

Answer:

This is not a problem. The only time you should receive the DC329019 message is when you have a DDS connection between two CVs and those CVs have communicated successfully with each other at some point. 

 

If you get on the 19.0 CV and enter command: 

DCMT D DIST RM 

You would see an entry for either a DSI_CLI or SRV if the CVs have connected via your DDS line and have previously been used. (example - you went from SATDAYNA to FABDAYNC) If the DCMT D DIST RM at startup shows no entries, then you won't get the DC329019 message. 

 

In my CV I had no DDC329019 until I connected from one CV to the other thru my dds vtam line. 

My DCMT D DIST RM command shows on my TECHDC40 CV this: 

RM Name Status Startup time (UTC) PndResync 

TECHDC50::DSI_CLI Open 2016-11-30-18.46.06.107469 0 

TECHDC50::DSI_SRV Open 2016-11-30-18.46.06.107469 0 

The same command on TECHDC50 CV of (19.0) shows this: 

RM Name Status Startup time (UTC) PndResync 

TECHDC40::DSI_CLI Open 2016-11-30-18.46.12.855827 0 

TECHDC40::DSI_SRV Open 2016-11-30-18.46.12.855827 0 

If I delete these DIST RM connections on my TECHDC50 CV via a commands like this: 

DCMT V DIST RM 'TECHDC40::DSI_CLI ' 

and 

DCMT V DIST RM 'TECHDC40::DSI_SRV' 

and shutdown and restart the CV, I get no DC329019 message until I do a request from my CV to the other CV thru DDS. Then DCMT D DIST RM will show the SRV or CLI entries again