MySQL AC and IM GUI provide different results

Document ID : KB000122427
Last Modified Date : 06/12/2018
Show Technical Document Details
Issue:
When creating a monitoring profile for MySQL probe using the Infrastructure Manager (IM) - everything worked fine. But when opening the configuration in AdminConsole (AC), and using only default templates, opening the AC GUI deactivates all checkpoints, without any "save" button being pressed.

 
Cause:
Note: - Below steps are not required if, only Admin console is used or if Admin console is used first and after that Infrastructure Manager ( IM).
 
Below steps are required only when IM is used first, and Admin console is opened after to view the settings reflected or not. 
 
It is not recommend to use both admin console and IM for the settings of probe.
 
Resolution:
Step 1: Open the Mysql probe in Raw Configure.
raw config

Step 2: Click on “New Key” under setup. Provide the key name “default_modify” and value “1” and click OK.
new key

Step 3: Once we configured the above parameters, then open the profile in oracle probe through IM and make all check point as static
(right click on checkpoints) and click OK.
edit profile


Step 4: Now if you open the same profile in admin console you can see same setting as IM.
Additional Information:
As outlined here in this important note: Important! Configuration of the probe—through the Unified Management Portal (UMP), using the Admin Console portlet (AC)—is not compatible with the configuration through the Infrastructure Manager interface. Do not mix or interchange configuration methods! If you do, the result will be unpredictable.