Is there a way to configure the CAM fragment size from the command line?

Document ID : KB000045214
Last Modified Date : 19/03/2018
Show Technical Document Details
Introduction:

Is there a way to configure the CAM fragment size from the command line?

 

 

Environment:
All versions of CA Client Automation
Instructions:
The CAM fragment size can be configured using the following command line:

camconfig %computername% *CONFIG fragment_size=<value>
camsave persist (To save the changes permanently to cam.cfg)

Ex: camconfig %computername% *CONFIG fragment_size=1024
      camsave persist
      
Note: You do not need to recycle the CAM service for the configuration changes to take effect.
Additional Information:
To read more about configuring the CAM fragment size based on your environment please refer techdoc KB000009418.