How can I apply PTF RO99859?

Document ID : KB000073536
Last Modified Date : 15/03/2018
Show Technical Document Details
Introduction:
I am unable to apply PTF RO99859. In the holddata it indicates to apply PTF RO96371 before applying this PTF. 
But I cannot apply PTF RO96371 due to an error hold that is resolved in PTF RO99859. 
So how do I go about applying this PTF?  
I got error messages: 

CAUSER SYSMOD SUMMARY REPORT FOR APPLY CHECK PROCESSING
CAUSER FMID MESSAGE ID PAGE ERROR DESCRIPTION AND POSSIBLE CAUSES
RO96371 CAS9E10 GIM35901I 1 ERROR HOLD AR96371 WAS NOT RESOLVED.
PAGE 0003 - NOW SET TO TARGET ZONE CAIT DATE 03/14/18 TIME 08:06:23 SMP/E
SYSMOD STATUS REPORT FOR APPLY CHECK PROCESSING SYSMODS APPLIED - 0
NOTE: '-' INDICATES THE REQUISITE SYSMOD OR HOLD CONDITION IS NOT SATISFIED
'*' INDICATES THE NON SATISFIED REQUISITE SYSMOD OR HOLD CONDITION IS B
'#' INDICATES THE SUPERSEDING SYSMOD WAS NOT PROCESSED
SYSMOD STATUS TYPE FMID REQUISITE SYSMODS, SUPBY SYSMODS, HOLD REA
RO96371 HELD PTF CAS9E10 PRE RO95587
HOLDE -AR96371
CAUSER RO96371
 
Question:
How can I apply PTF RO99859? 
 
Environment:
CA Common Services 14.1 - z/OS supported releases - 
Answer:
With native SMP/E you have to code the BYPASS(HOLDERROR) to apply PTF RO96371. 

Then please follow the holddata listed in PTF RO99859: 

************************** 
* STEPS TO PERFORM * 
************************** 

1. APPLY PTF RO96371 if it has not yet been applied. 

2. Execute the "UCLIN" JCL below to change the DISTLIB for ESMSH to 
AAW0ZFS1. 

3. APPLY this PTF. 

4. To ACCEPT this PTF: 
a. If RO96371 has not been ACCEPTed, specify both RO96371 and this 
PTF in the same SELECT statement. 
b. If RO96371 has already been ACCEPTed, specify this PTF only. 

5. After ACCEPTing this PTF, delete the ESMSH member from the AEG1SHSC 
distribution data set if it exists.