Getting FSUM7351 not found error running CA OPS/MVS Event Management and Automation UNPAX JCL listed in the Install guide.

Document ID : KB000005829
Last Modified Date : 14/02/2018
Show Technical Document Details
Issue:

When running the sample UNPAX JCL listed in the Install guide on page 42 of the CA OPS/MVS Event Management and Automation Installation PDF, I am getting the following errors:

CD: FSUM7351 not found
PAX: FSUM7351 not found

//*********************************************************************
//* THIS SAMPLE JOB CAN BE USED TO INVOKE THE PAX COMMAND TO CREATE         *
//* THE PRODUCT-SPECIFIC INSTALLATION DIRECTORY.                                           *
//*                                                                                                                         *
//* THIS JOB MUST BE CUSTOMIZED AS FOLLOWS:                                                   *
//* 1. SUPPLY A VALID JOB STATEMENT.                                                                   *
//* 2. REPLACE "YOURUSSPAXDIRECTORY" WITH THE NAME OF THE USS                    *
//* DIRECTORY USED ON YOUR SYSTEM FOR PAX ESD DOWNLOADS.                         *
//* 3. REPLACE "PAXFILE.PAX.Z" WITH THE NAME OF THE PAX FILE.                           *
//* NOTE: IF YOU CONTINUE THE PARM= STATEMENT ON A SECOND LINE,                 *
//* START ENTERING CHARACTERS IN COLUMN 16 AND MAKE SURE                           *
//* THE 'X' CONTINUATION CHARACTER IS IN COLUMN 72.                                        *
//*********************************************************************
//UNPAXDIR EXEC PGM=BPXBATCH,
// PARM='SH CD /u/rif30/; PAX -RVF B60000ESACS.PAX'
//*UNPAXDIR EXEC PGM=BPXBATCH,
//* PARM='SH CD /YOURUSSPAXDIRECTORY/; PAX X
//* -RVF PAXFILE.PAX.Z'
//STDOUT DD SYSOUT=*
//STDERR DD SYSOUT=*

 

Environment:
OPS/MVS Event Management and Automation 13.0 Incremental release
Cause:

UNIX parameters in the JCL need to be lower case (case sensitive).

Resolution:

JCL did not work on the mainframe was due to UNIX parameters in the JCL needing to be lower case (case sensitive).

Change this:
// PARM='SH CD /u/rif30/; PAX -RVF B60000ESACS.pax.Z'

To this:
// PARM='sh cd /u/rif30/; pax -rvf B60000ESACS.pax.z'
 

Additional Information:

1) Remember to ftp your pax files to your unix directory with the .z extension.
2) Remember to make sure your JCL statement for the UNPAX job maintains the UNIX parameters in lowercase: sh, cd, pax, -rvf, pas.z.

Reference:

OPS/MVS r13: Create a Product Directory from the Pax File
OPS/MVS r12.3: Create a Product Directory from the Pax File