FRAMES="NO" is included on the process tab along with the parameter 'REPLICATE'

Document ID : KB000090144
Last Modified Date : 14/04/2018
Show Technical Document Details
Issue:
FRAMES="NO" is included on the process tab along with the parameter 'REPLICATE'
Resolution:

Symptoms

These messages are returned from several activated SAP jobs that failed:

U0011006 Job 'JOBS.IMEABATCH1' (RunID '0001080116' / Workflow-RunID: '0001080114') on Host 'VMBATCHJOB01' ended normally. Remote ID=3932

U2004012 Could not interpret line 'R3_ACTIVATE_REPORT REPORT='ZBCE_PURGE_CUSTOM...'.

U2000117 The command 'R3_ACTIVATE_REPORT' does not support the parameter 'REPLICATE'.


Cause

Here is the explanation for this behavior:

FRAMES="NO" on the "Process" tab is correct if the "Frames" parameter on the "Form" tab is NOT checked.

The problem is that FRAMES="NO" is not supported by the standard XBP interface, and REPLICATE is not supported by the Automic interface. If both Interfaces are active, then these parameters will not work together on the Process tab.

 ------------------------------------------------------

So the sequence that is occurring is:

1) The SAP job is executed and the "Process" tab is evaluated.

2) The FRAMES parameter is detected and the Automic Interface is envoked.

3) When the REPLICATE parameter also is detected on the "Process" tab, this message is returned for the Automic Interface:

U2000117 The command 'R3_ACTIVATE_REPORT' does not support the parameter 'REPLICATE'.

or

U2004012 Could not interpret line 'R3_ACTIVATE_REPORT VARIANT='',REPORT=... (new v9 job)*

4) When the FRAMES parameter is detected on the "Process" tab, this message is returned for the XBP Interface:

U2000117 The command 'R3_ACTIVATE_REPORT' does not support the parameter 'REPLICATE'.

----------------------------------------------------------------------------------- 

So this is the expected behavior by design - these two parameters should never be on the "Process" tab together for the 'R3_ACTIVATE_REPORT'.


Resolution

Remove FRAMES="NO" or the parameter 'REPLICATE' from the process tab