CA XCOM Data Transport Error Message CPF1269 Program Start Request- Major/Minor 080F 6051 rc 715,0

Document ID : KB000027951
Last Modified Date : 14/02/2018
Show Technical Document Details

Symptoms: 

CA XCOM Data Transport Error Message CPF1269 Program Start Request- Major/Minor 080F 6051 rc 715,0

Cause: 

This message is most likely a security violation due to the device being allocated to the wrong subsystem. To correct, this vary the device off and back on to be allocated to the correct subsystem.

Resolution:

Check the communication entries for the XCOM subsystem XCOM2SBS by doing a:

DSPSBSD XCOM2SBS

from the command line. Next select the option for communication entries. You should have something like the following:

devicemodejob descriptionlibraryusermax active
XCOMDEVXCOMMODEXCOMXCOM2XCOM*NOMAX

where XCOMDEV is the device used for XCOM transfers, and XCOM2 is the library where XCOM is installed. Make sure the user is XCOM as that is where the security violation comes from.

This problem is a result of the device being allocated to QCMN which has a default user of *SYS instead of XCOM. XCOM does not recognize this, therefore the security violation results.

If the communication entry is correct already, then you simply need to vary the device off and back on again to make sure the device is allocated to XCOM2SBS. The device can be varied on/off with the

WRKCFGSTS *DEV XCOMDEV

Once device is varied off, start XCOM2SBS using

STRSBS XCOM2SBS

from the command line. Once XCOM2SBS is active, use

WRKCFGSTS *DEV XCOMDEV

to vary the device on. Now device should be allocated to XCOM2SBS.