CA View - Why is the ID on the Sysout Selection List shown as".0?

Document ID : KB000025539
Last Modified Date : 14/02/2018
Show Technical Document Details

Question : 

Why is the ID on the Sysout Selection List shown as".0?

 

VIEW 2.0 ALL ------------- SYSOUT SELECTION LIST ------------------------------
 COMMAND ===>                                               SCROLL ===> PAGE
                                                                               
SEL   ID    JOBNAME  JOBID     ARCH DATE/TIME LOC     LINES   PAGES   XCODE 
      ".0  STICH01S  JOB04329  06/09/08 13:34 TAPE      312       7       
      ".0  STICH01S  JOB04325  06/09/08 13:30 TAPE      167       5   

 

Answer : 

The JES2LVL  parameter is set to an incorrect value. Change the value to JES2LVL=5 by performing the following steps :-

Run SARINIT with NAME = high-level-qualifier of the database.

This will produce a list of initialization parameters that are currently is in effect.

  1. Check the list of initialization parameters for the value of JES2LVL If the default was taken, JES2LVL will be set to 2 and cause the unusual ID name.

  2. Change the parameter to JES2LVL=5 and run SARINIT to store the new value in the database.

  3. Recycle the started task to get it to pick up the new value.

  4. All newly collected reports will have the correct ID.