What is Automatic DTF Switching mentioned in the BND7141I message when the distribution job runs?
Automatic Switching is a process that Unicenter CA-Bundl uses to change the DTF that is defined to a report when it does not exist to a default DTF. The BND7138E message is issued to inform the Administrator the DTF was not found.
The "default" DTF record Unicenter CA-Bundl will use for the switch is called (STANDARD) (STD). If the default DTF record is not defined, the following messages are issued:
BND7140I No DTF record (STANDARD) (DTF) exists.
BND7141I Automatic DTF switching disabled.
To prevent the BND7140I and BND7141I messages, define a DTF record with a Device ID = (STANDARD) and a mode of (DTF).
*Note - The parentheses are required*