After applying SP1 on MSP 2013, a project can no longer be launched to MSP from Clarity if that project has a baseline.
Project starts to load in MSP, but then gives the following error message:
Run-time error '91':
Object variable or With block variable not set
Note: The Project Management User Guide for Clarity 13.2 and 13.3 do not mention whether or not MSP 2013 SP1 is supported.
Any local client environment using the CA PPM Legacy MSP Interface and MSP 2013 Service Pack 1.
Roll back to MSP 2013 without any Service Packs.
Due to the timing of when it was released, MSP 2013 Service Pack 1 has not been tested with the CA PPM Legacy MSP Interface. Since it has not been tested, this also means that it is not supported.
Do not apply Service Pack 1 to Microsoft Project 2013 if you are using the CA PPM Legacy MSP Interface.
Microsoft Project 2013 Service Pack 1 is supported for integration with the new CA PPM Release 14.2+ MSP Interface option.
Reference the Change Impact and Upgrade Guide for CA PPM 14.1, 14.2, 14.3
To help identify the exact supported service packs on a MSP version, the Project Management User Guide includes the supported service pack levels for each MSP version.
Reference TEC615024: All the actuals are zeroed out when launching a project from Clarity to MSP 2013 with SP1