About stopping STC of SYSVUSER when stopping STC of SYSVIEW

Document ID : KB000015782
Last Modified Date : 14/02/2018
Show Technical Document Details
Introduction:

This document describes the stopping of the SYSVUSER STC at the same time when stopping the SYSVIEW STC, without entering additional commands.

Question:

How can we stop SYSVIEW and SYSVUSER with 'P SYSVIEW’ command?

Answer:

We can use STOPCMD parmlib member for this question.

The STOPCMD member is located in the CA Sysview library prefix.CNM4BPRM.

It is possible to use STOPCMD member as follows.
Please specify the contents of ')IF JOBNAM=SYSVIEW' statement and others above the ')EOF ' statement as follows;

<Sample>
)IF JOBNAME=SYSVIEW
    )IF JOBACTIVE=SYSVUSER
      STOP SYSVUSER
    )ENDIF
)ENDIF

)EOF